Water recycling. Every reverse osmosis configuration we manufacture.
Treated effluent, brackish water and seawater recovered to a quality that can be returned directly to production, utilities or irrigation.

Water is purchased once and paid for again at the drain.
Industrial sites across the Gulf carry two separate water costs: the tariff paid for supply and the cost of disposing of effluent. In a growing number of jurisdictions the discharge consent itself has become the binding constraint, independent of price.
Water recycling addresses both. A membrane plant sized against the actual feed analysis returns the majority of treated effluent to cooling systems, boiler make-up, process lines or irrigation, and reduces the volume leaving the site. reThinking Water supplies the complete chain: pre-treatment, membrane systems, cleaning facilities and the chemical programme required to protect membrane life.
Outcomes achieved on comparable installations:
- Recovery of 60 to 85 per cent of treated effluent for reuse, subject to feed quality
- Reduced purchase of fresh water and reduced tanker movements
- Lower discharge volume and a correspondingly simpler compliance position
- Boiler and cooling tower make-up supplied at the quality those systems require
- A quantified payback supported by measured consumption and tariff data
Reverse osmosis systems we manufacture.
Each system is skid-mounted in our own facility and supplied with the pre-treatment, instrumentation and cleaning systems required for sustained operation.
Brackish water RO (BWRO)
For well, bore and brackish supplies at low to moderate salinity. The standard configuration for process water and boiler make-up.
Seawater RO (SWRO)
High-pressure systems with duplex or stainless steel high pressure sections and energy recovery, for coastal installations and sites without a fresh water supply.
Wastewater reuse RO
Tertiary reverse osmosis downstream of a membrane bioreactor or ultrafiltration stage, producing reuse-grade water from treated effluent.
Two-pass & high-recovery RO
A second pass where very low conductivity is required, or inter stage boosting where recovery must be increased because reject disposal is costly.
Disc-tube RO (DTRO)
Open-channel modules for landfill leachate and for high-fouling, high-salinity streams in which spiral elements have a short service life.
Nanofiltration (NF) & ceramic NF
Softening and the removal of hardness and colour where full desalination is not required, including ceramic elements for hot, oily and chemically aggressive streams.
RO with EDI / mixed bed
Demineralised and ultrapure water for boiler feed, pharmaceutical and electronics applications, using continuous electrodeionisation or polishing resin.
Containerized & mobile RO
Reverse osmosis installed in an ISO container for remote sites, accelerated programmes and rental.
RO revamp, membranes & spares
Replacement membranes, pumps, vessels and instrumentation, together with performance normalisation on systems supplied by others.
Why clients place membrane scopes with us:
- Systems are sized against the client's own water analysis rather than a standard catalogue duty
- Pre-treatment is engineered together with the membrane system, which governs membrane life
- Clean-in-place facilities and the antiscalant and biocide programme are supplied within the same scope
- Containerized systems are available for rental, allowing performance to be demonstrated before purchase
- Membranes, spares and technical support remain available after commissioning
Questions raised during procurement.
What recovery can be achieved?
Recovery is governed by salinity and by the fouling potential of the feed. Treated effluent commonly supports 60 to 85 per cent recovery. Higher recovery is technically achievable, although the cost of managing the resulting reject increases significantly.
How is the reject managed?
The reject is discharged within the applicable limits, concentrated further, or evaporated. Please refer to Evaporators and zero liquid discharge.
Can an existing reverse osmosis plant be improved?
Yes. In most cases the limiting factor is pre-treatment or the cleaning regime rather than the membranes themselves, and correction is considerably less costly than replacement.
Other solutions.
Industrial treatment plants
Turnkey effluent treatment plants — tested, designed, manufactured, installed and commissioned by one team.
Learn moreEvaporators & ZLD
Thermal systems for brine, RO reject and effluent that cannot be discharged at all — built around the smallest possible stream.
Learn moreContainerized & rental plants
Factory-built and tested treatment in ISO containers and on skids — to buy, or to rent while you decide.
Learn moreTell us about your water.
Send your flow and effluent analysis and an engineer comes back with a treatment concept — no obligation.
hammad.nasir@rtwatertreatment.com
talha.nasir@rtwatertreatment.com
+966 58 155 6758
